How to Waterless Wash and Wax – Aero Cosmetics

Waterless Wash & Wax
Hand Application
(Also see How to use the Wash Wax Mop)
Fold some towels in half twice to form a square, wet them with water or Wash Wax ALL, and then wring them out so they are only damp. Also, fold some dry towels in the same manner and have them available.
(See Note: Towels)

Start at the highest point of the vehicle you plan to clean. Clean upwind of the dirty areas so the spray mist will only land on areas that have not been cleaned.

Spray an area you can comfortably clean before Wash Wax ALL the dries – approximately 2ft. by 4ft. or smaller.

Take the damp towel and wipe the area you just sprayed with Wash Wax ALL. (If the vehicle is not very dirty, you can skip this step)

Dry the area with a dry towel before the Wash Wax ALL dries.

Continue using steps 3 through 5 for the rest of the vehicle, unfolding and re-folding the towels to expose new clean sides.

Work your way down to the lower portions of the vehicle. We recommend cleaning the windows last.

The process is the same throughout the entire vehicle; spray on and wipe off. Replace the towels as needed when they become dirty. For hard to reach areas, we recommend using the Wash Wax Mop.

For areas that have dried on bugs, we recommend you pre-spray the area with Wash Wax ALL (Blue) and let it soak for 5-10 minutes. After it has soaked in, re-spray the area and use the Aero Scrubber to break up the bugs.
Then, use a towel to dry and clean the area before the Wash Wax ALL dries.